2002 Ford F 250 4WD Super Duty Technician High Pressure Pump Guide For the...
download Note: As a general rule 7.3 Power stroke engines require 500 psi ICP (1.0 volts ICPv) minimum to start. 1.) ICP System Diagnostics P1211 sets if ICP is 410 psi above or 280 psi below desired...
View Article2000 Chevy Truck S10/T10 P/U 2WD Fuel Rail REMOVAL PROCEDURE
download REMOVAL PROCEDURE 1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure. CAUTION: Refer to Battery Disconnect Caution in Service Precautions. 2. Disconnect the negative...
View ArticleON?VEHICLE INSPECTION INSPECT INJECTOR OPERATION
download ON?VEHICLE INSPECTION 1. INSPECT INJECTOR OPERATION Check operation sound from each injector. (a) With the engine running or cranking, use a sound scope to check that there is normal operating...
View ArticleSuzuki Swift GTi Extra Injector Controller Installation
download Monitoring of the duty cycle of the OEM injectors. • Ability to drive more than one injector. • The magnetic pickup will no longer be used for speed sensing. This will allow interfacing to any...
View ArticleSUBARU FUEL INJECTOR REMOVAL PROCEDURES
download When removing and/or replacing the fuel injector(s), it’s imperative that the below instructions be strictly followed. Failing to do so may result in damage to the injector(s). Applicability:...
View Article2002 Buick Regal Fuel Injector Circuit Diagnosis
download Circuit Description The control module enables the appropriate fuel injector on the intake stroke for each cylinder. An ignition 1 voltage is supplied directly to the fuel injectors. The...
View Article2004 Ford F-Super Duty 250-550 Fuel Injectors Removal Installation
download All vehicles 1. Remove the valve cover. For additional information, refer to Section 303-01C. 2. Disconnect the fuel injector electrical connector. Two-piece head tube 3. NOTE: Some engines...
View Article3126E TRUCK ENGINE CKM Unit Injector – Removal Procedure
download Start By: A. Remove the valve mechanism cover. Refer to Disassembly and Assembly, “Valve Mechanism Cover – Remove and Install”. NOTICE Keep all parts clean from contaminants. Contaminants may...
View Article1997 Ford F-250/350/Super Duty Fuel Injector REMOVAL AND INSTALLATION
download Removal 1. Disconnect the battery ground cables. 2. WARNING: RED-STRIPED WIRE HARNESS CARRIES 115V DC. SEVERE ELECTRICAL SHOCK MAY BE RECEIVED. DO NOT PIERCE. CAUTION: Do not attempt to...
View Article2001 Chevrolet Corvette Fuel Injector Coil Test
download CIRCUIT DESCRIPTION The Powertrain Control Module (PCM) enables the appropriate fuel injector on the intake stroke for each cylinder. A voltage is supplied directly to the fuel injectors. The...
View Article
More Pages to Explore .....